Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

408 DCFM Enterprise User Manual

53-1001357-01

Editing a LAG

Use the following procedure to change members and policies in a link aggregation group (LAG).

1. Select Configure > CEE Switch > CEE from the menu bar.

The CEE Configuration dialog box displays, showing the status of all CEE-related hardware and

functions.

2. Select the link aggregation group (LAG) from the Products/Ports table.

3. Click Edit.

The Edit LAG dialog box displays.

FIGURE 155 Edit LAG dialog box

4. Modify the following LAG parameters as required:

5. Configure the following LAG parameters:

NOTE

A LAG restriction exists whereby you can add 802.1x-enabled ports to a LAG, but the port will

fail when the LAG is saved to the switch. 802.1x-enabled ports are not supported.

• Status - Enabled or Disabled. You must enable the LAG to use the CEE functionality.

• Name - The system-generated, read-only LAG name, assigned when the LAG is added.

• LAG ID - The LAG identifier, which is not an editable field.

• Interface Mode - L2 or none.

• A port must be in L2 Mode if you are adding the port as a member of a LAG.

• You cannot change the Interface Mode from L2 to none if the LAG is assigned to a

VLAN.

• L2 Mode - Select the L2 mode (Access or Trunk).