Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

504 DCFM Enterprise User Manual

53-1001357-01

Adding encryption targets

Adding an encryption target maps storage devices and hosts to virtual targets and virtual initiators

within the encryption switch.

NOTE

It is recommended that you zone the host and target together before configuring them for

encryption. If the host and target are not already zoned, you can still configure them for encryption,

but afterward you will need to zone the host and target together, and then click the Commit button

to commit the changes. If you attempt to close the Encryption Targets dialog box without committing

the changes, you are reminded of uncommitted changes in the Management application.

1. Select Configure > Encryption from the menu bar.

The Encryption Center dialog box displays the status of all encryption-related hardware and

functions at a glance. It is the single launching point for all encryption-related configuration

2. Select the encryption group, switch, or encryption engine to which you want to add the target.

3. Click Encryption Targets.

The Encryption Targets dialog box displays.

4. Click Add.

The Configure Storage Encryption welcome panel displays. The welcome panel explains the

wizard’s purpose, which is to configure encryption for a storage device (target).

FIGURE 212 Configure Storage Encryption welcome panel