Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

DCFM Enterprise User Manual 507
53-1001357-01
Adding encryption targets
16
7. Click Next.
The Select Hosts panel displays. This panel lists all hosts in the same fabric as the encryption
engine. There are two available methods for selecting hosts: select from a list of known hosts
or manually enter the port and node world wide names.
FIGURE 215 Select Hosts dialog box
a. Select a maximum of 1024 hosts from the Host Ports in Fabric list, and click the right
arrow to move the host to the Selected Hosts list. (The Host Port WWN column contains all
the target information that displays using the nsshow command.)
b. Manually enter world wide names in the Host Port WWN and Host Port WWN text boxes, if
the hosts are not included in the list. You must fill in both the Host Port WWN and the Host
Node WWN. Click the Add to Selected Hosts button to move the host to the Selected Hosts
list.
8. Click Next when you are finished selecting hosts or manually entering the WWNs.
The Name Container panel displays.
The name container step in the wizard enables you to specify a name for the target container
that is created in the encryption engine to hold the target configuration data.
9. The container name defaults to the target WWPN. You can, however, rename the container
name. If you want to specify a name other than the default, enter a name, using a maximum
number of 31 characters. Letters, digits, and underscores are allowed.