Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

DCFM Enterprise User Manual 577
53-1001357-01
Enabling failover on a traffic isolation zone
18
3. Select an FC fabric from the Zoning Scope list.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
4. Right-click the traffic isolation zone you want to disable in the Zones list and clear the
Configured Enabled check box.
5. Click OK or Apply to save your changes.
A message displays informing you that any zones or zone configurations you have changed will
be saved in the zone database, and warning you to make sure no other user is making changes
to the same areas. The traffic isolation zone is not disabled until you activate a zone
configuration in the same zone database.
Enabling failover on a traffic isolation zone
NOTE
Traffic isolation zones are only configurable on a Fabric OS device.
Use this procedure to enable failover on a traffic isolation zone.
1. Select Configure > Zoning > Fabric.
The Zoning dialog box displays.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
4. Right-click the traffic isolation zone you want to enable failover on in the Zones list and select
Configured Failover.
5. Click OK or Apply to save your changes.
A message displays informing you that any zones or zone configurations you have changed will
be saved in the zone database, and warning you to make sure no other user is making changes
to the same areas.