Data Center Fabric Manager Professional User Manual v10.3.X (53-1001355-01, November 2009)

DCFM Professional User Manual 275
53-1001355-01
Editing a CEE switch
11
6. Continue to configure the following LAG parameters. These parameters are disabled until you
add a CEE port to the LAG members table.
• Mode - Sets all ports added to the LAG members table in either Static or Dynamic mode.
The default is Dynamic, Active, but LAG members can be Active or Passive if the LAG
member is Dynamic.
• Type - Sets the limit on the size of the LAG. The type values include Standard, where the
LAG is limited to 16 ports, and Brocade, where the LAG is limited to four ports. The default
is Standard.
NOTE
The 8 Gbps 16-FC-ports, 10 GbE 8-Ethernet Port has three anvil chips and each anvil chip
supports eight 10 Gbps Ethernet ports. You cannot create Brocade-type LAGs from
different anvil chips. If you do, an error message displays and only the first port is
considered as part of the LAG.
7. When you have finished configuring the policies, click OK.
The CEE Confirmation and Status dialog box displays.
8. Review the changes carefully before you accept them.
9. Click Start to apply the changes, or click Close to abort the operation.
If the operation was successful, the new LAG displays in the custom products list in the CEE
Configuration dialog.
Editing a CEE switch
1. Select Configure > CEE Switch > CEE from the menu bar.
The CEE Configuration dialog box displays, showing the status of all CEE-related hardware and
functions.
2. Select the CEE switch from the Products/Ports table.