Data Center Fabric Manager Professional User Manual v10.3.X (53-1001355-01, November 2009)

DCFM Professional User Manual 297
53-1001355-01
Adding an ACL to a switch
11
FIGURE 97 Access Control List dialog box
4. Click Add and select Standard or Extended from the Add list.
The Add Extended Access Control List includes all the Standard ACL features plus two
additional features: Destination and Ether Type. The ACL parameters are described below.
FIGURE 98 Add Extended Access Control List dialog box
5. Configure the following Access Control List parameters.
NOTE
You cannot duplicate Action and Source parameters in an existing Standard ACL. You cannot
duplicate Action, Source, Destination, and Ether Type parameters in an existing Extended ACL.
• Sequence - The sequence number that tracks all the ACL entities defined globally in the
system. If you assign a Sequence number that is the same as an existing ACL Entity, an
overwrite warning displays. After the overwrite operation, the system again checks for
duplicates, then it creates the new ACL entity.