Data Center Fabric Manager Professional User Manual v10.3.X (53-1001355-01, November 2009)

DCFM Professional User Manual 301

53-1001355-01

Assigning an ACL to a port or link aggregation group

An access control list (ACL) cannot be assigned to a port when the port is a member of a link

aggregation group (LAG). An ACL can be assigned to a LAG, however.

NOTE

The ports and the ports in a link aggregation group (LAG) for the selected switch must be in Layer 2

(L2) mode. If the ports or ports in a LAG are not in L2 mode, the ACL parameters are disabled.

1. Select Configure > CEE Switch > CEE from the menu bar.

The CEE Configuration dialog box displays, showing the status of all CEE-related hardware and

functions.

2. Select a port or LAG, and click Edit.

3. Click the Access Control List tab on the Edit Port/Edit LAG dialog box.

The Access Control List dialog box displays.

4. Click the Assign Access Control List to <port name> checkbox.

You can unassign an ACL by deselecting the Assign an ACL to <port_name> checkbox.

FIGURE 99 Assign ACL to port dialog box

5. Select an ACL from the Available ACLs list.

The ACL name is suffixed with its type (standard or extended) in parentheses; for example,

Human Resources (Extended). The details of the selected ACL are displayed in the Assigned

ACL Details table, shown in Figure 99.

6. Click OK to commit the assign the ACL to the port or LAG.

The CEE Confirmation and Status dialog box displays.

7. Review the changes carefully before you accept them.

8. Click Start to apply the changes, or click Close to abort the operation.