Data Center Fabric Manager Professional User Manual v10.3.X (53-1001355-01, November 2009)

DCFM Professional User Manual 59

53-1001355-01

Management server and client

246 jboss.jrmp.invoker.port - port 5 RMI/JRMP invoker port Client–Server No

246

jboss.pooled.invoker.port - port 6 Pooled invoker port Client–Server No

246 jboss.connector.socket.port - port 7 Socket invoker port Server No

2461

jboss.web.ajp.port - port 8 AJP 1.3 connector port Server No

2461

jboss.web.service.port – port 9 Web service port Server No

2461

connector.bind.port – port 10 Port to listen for requests on Server No

1 Port is not configurable (either in the switch or the Management server).

2 Every FTP session requires an additional port which is randomly picked. If the firewall is

enabled then FTP operation (used for firmware download, technical support, firmware import

(from client-server) and so on.) will fail.

3 Ports configurable in the switch and the Management server. Port must be the same for all

switches managed by the Management server.

4 Ports used to launch the Web Tools application for Fabric OS switches from the Management

client. This is applicable only when the FOS version is earlier than 6.1.1.

5 Port 80 is the default web server port number. If you set the web server port number to a port

other than the default, you must open that port in the firewall.

6 The Syslog listening port is configurable in the Management server. The switch always sends

syslog messages to port 514. If you have any other syslog daemon on the Management server

machine already listening to 514, then the Management Server can be configured to listen to a

different port. You must manually configure relay in existing syslogd to forward the syslog

messages to the Management Server listening on the configured port.

7 The Management server tries to find a contiguous block of 13 ports from the starting port

configured (for example, 24600); if any port in this range is not available for the Management

application, then you must provide a new starting port. Note that Port 1 to Port 12 in “Ports”

column of the table above are not separately configurable and those ports vary based on the

starting port number configuration (specified as Port 0 in the above table). The port numbers

mentioned in the table above are the default ports (for example, when 24600 is selected as the

starting port number).

TABLE 14 Ports

Port Number Ports Description Communication Path Open in Firewall