HP Intelligent Infrastructure Analyzer Software User Guide

NOTE: Connectivity state information is available only for monitored switches.
Using SAN Topology
To view the graphical topology of SAN:
• Click SAN Topology on the navigation menu. A Topology page is displayed with its component
and sub-components.
This page consists of:
◦ A graphical view of the topology depicting the connectivity as shown in Figure 7
(page 15).
◦ A component based view is categorized based on their type and connectivity in the SAN.
NOTE: The connectivity between any two SAN components is shown only by a single line, even
if there are multiple physical connections between the components. In case of multiple physical
connections, a hatch (||) is shown across the line at the center.
Besides the hatch number of good connections or number of total connections will be shown as
for example: || 2/3. In this example, out of 3 connections 2 are in good state. State of connections
are shown in the tool tip.
Figure 7 SAN Topology
SAN Inventory
The inventory list shows the following details:
• SAN Switches
• Connected Storage devices and HBAs
If you click a component, the details are displayed as shown in Figure 8 (page 16).
SAN Inventory 15