HP BladeSystem c7000 Carrier-Grade Enclosure Maintenance and Service Guide

2. Remove the cage nuts from the rear mounting holes.
To replace the component, reverse the removal procedure.
Rack Mount
NOTE: The U locations are noted in the following procedure for enclosures installed in the lower
portion of the rack. When installing multiple enclosures into the rack, use the U locations in
parentheses for the top enclosure.
To remove the components:
1. Remove the cage nuts from the middle hole of U9 (U20) and top hole of U4 (U15) in the front
mounting rails.
2. Use a Torx screwdriver to unscrew the rack mount brackets from the top and middle holes of
U1 and U2 (U12 and U13).
To replace the components, reverse the removal procedure.
Rack Mount 15