HP 3PAR Cluster Extension Software Installation Guide for Windows (5697-1822, March 2012)

8. Specify whether the installation directory will apply to all nodes selected for installation:
• If you want to use the same destination location for all nodes selected in the previous
step, select the Use the same destination location for all the selected remote cluster nodes
check box, and then click Next.
• If you do not want to use the same destination for all nodes selected in the previous step,
do not select the Use the same destination location for all the selected remote cluster nodes
check box, and click Next to continue.
9. For all remote cluster nodes: Accept the default location or enter a new location, and then
click Next.
10. The installer asks if you want to install a permanent license. Click Yes to install a permanent
license. Follow the instructions in to retrieve and install the license, and then click Finish.
CAUTION: You must perform the permanent license installation procedure separately on
each cluster node. Cluster-wide installation does not install a permanent license on remote
cluster nodes.
TIP: To start the configuration tool at the end of the installation, select the Launch Configuration
Tool check box before you click Finish.
11. To perform the required configuration steps, follow the instructions in the HP 3PAR Cluster
Extension Software Administrator Guide.
HP 3PAR Cluster Extension maintenance
Modifying the 3PAR Cluster Extension installation
Once 3PAR Cluster Extension is installed, you can modify the installation by adding or removing
components.
1. Start the 3PAR Cluster Extension InstallShield wizard:
a. Depending on your version of Windows, do one of the following:
• For Windows Server 2003: Select Start→Control Panel→Add or Remove Programs.
• For Windows Server 2008/2008 R2: Select Start→Control Panel→Programs and
Features.
• For Server Core or Hyper-V Server: Run the 3PAR Cluster Extension installation
package from the command line. Continue to Step 2.
b. Select HP 3PAR Cluster Extension. Click Change/Remove (Windows Server 2003) or
Uninstall/Change (Windows Server 2008/2008 R2).
The InstallShield maintenance window appears.
2. Select Modify, and then click Next.
The Select Features window appears.
3. Select the check boxes next to the features you want to install, clear the check boxes next to
the features you want to remove, and then click Next.
The Cluster node selection window appears.
4. Select the cluster nodes to modify, and then click Next.
The InstallShield wizard notifies you that remote maintenance is in progress. For each selected
cluster node, the wizard notifies you that maintenance was successful or unsuccessful.
5. For each remote maintenance confirmation window, click OK.
The Maintenance Complete window appears.
HP 3PAR Cluster Extension maintenance 13