HP Jetdirect Print Servers - Administrator Guide

ENWW HP Jetdirect Configuration Page 237
23 UNABLE TO
ATTACH TO QUEUE
A failure was detected when the HP Jetdirect print server
tried to attach to one of the queues assigned to the print
server object. This may be because no servers are allowed
to attach to this queue. There may also be a networking or
security problem. Use PCONSOLE to make sure that
servers are allowed to attach to the queue, to delete the print
server object from the list of queue servers if you want the
HP Jetdirect print server to service other queues, or to
delete the queue and create a new one (the print server
object must be added to the list of queue servers).
When the HP Jetdirect print server is configured for multiple
file servers, the error is only displayed on the configuration
page if none of the file servers made the connection.
24 PSERVER CLOSED
CONNECTION
The NetWare print server requested a termination of the
connection with the HP Jetdirect print server. No error exists
or is indicated. Make sure the NetWare print server is
running, and restart it if necessary.
25 DISCONNECTING -
SPX TIMEOUT
The SPX connection to the print server was lost after the
connection had been made. This indicates a possible
network problem, or a problem with the print server. Make
sure all cables and routers are functioning correctly. Try
restarting the print server.
26 UNKNOWN NCP
RETURN CODE
The HP Jetdirect print server encountered an unexpected
fatal error after it had successfully connected to the file
server. A wide variety of failures could produce this error
message, including a downed file server or a network
router failure.
27 UNEXPECTED
PSERVER DATA
RCVD
The print server sent some data when the HP Jetdirect print
server had not given its permission to do so. This indicates
a possible print server problem, possibly a software
problem.
28 OUT OF BUFFERS The HP Jetdirect print server was unable to allocate a buffer
from its internal memory. This indicates all buffers are busy
due possibly to heavy broadcast traffic or large amounts of
network traffic directed to the print server.
29 UNABLE TO
SENSE NET NUMBER
The HP Jetdirect print server has been trying for over 3
minutes to determine the NetWare protocol used on the
network. Make sure that any file servers and routers are
operating correctly. Make sure that the settings for NetWare
frame type and source routing are correct.
2A NDS ERR:
EXCEEDS MAX
SERVERS
More queues were assigned than the HP Jetdirect print
server can handle. Remove one or more print queues from
the list to be serviced by Queue Server Mode.
Table 9.12 Error Messages (6 of 11)
Error Code and
Message
Description