HP Jetdirect Print Servers - Administrator Guide

ENWW HP Jetdirect Configuration Page 241
53 BAD BOOTP
TAG SI ZE
The tagsize in a vendor-specific field in the BOOTP reply
is either 0, or greater than the remaining number of
unprocessed bytes in the vendor-specified area.
54 BOOTP/RARP
IN PROGRESS
The HP Jetdirect print server is currently in the process of
obtaining its basic IP configuration information through
BOOTP/RARP.
55 BOOTP/DHCP
IN PROGRESS
The HP Jetdirect print server is currently in the process of
obtaining its basic IP configuration information through
BOOTP/DHCP, and has not detected any errors.
56 DHCP NAK The HP Jetdirect print server received a negative
acknowledgement message from the DHCP server in
response to a configuration request.
57 UNABLE TO
CONNECT DHCP SVR
The HP Jetdirect print server had received IP parameters
from a DHCP server, but communication with the DHCP
server has been lost. Check status of the DHCP server.
If an infinite lease was assigned, the print server will use the
IP address of the most recent DHCP server used, but
operation may be degraded until a DHCP server responds.
58 POSTSCRIPT
MODE NOT
SELECTED
The printer does not support AppleTalk or AppleTalk
extensions.
59 INCOMPLETE F/W -
MUST DOWNLOAD
Firmware download message. Currently downloading
firmware to the HP Jetdirect print server, or the download
did not complete properly.
5A TURN PRINTER
OFF / ON
Firmware download message. Download of firmware is
complete. Power off/on the HP Jetdirect print server.
5C DHCP BAD REPLY A bad reply was received from the DHCP server. Check your
DHCP server settings for this print server.
5D DHCP LEASE
DURATION TOO
SHORT
The DHCP lease times for this print server’s TCP/IP
configuration settings are too short. Reconfigure the DHCP
lease times on the DHCP server.
5E DHCP LEASE
RELEASED
The lease for DHCP-configured parameters, including the
IP address, have been released through a manual
configuration method, such as through the printer’s control
panel.
5F WINS
REGISTRATION
FAILED
Attempts to register the print server’s name on the WINS
server failed. Check for duplicate names, or verify the WINS
server configuration.
61 AUTO IP
CONFIGURED
An IP address could not be retrieved over the network. The
print server will default to an IP address using link-local
addressing in the form 169.254.x.x.
Table 9.12 Error Messages (10 of 11)
Error Code and
Message
Description