HP Jetdirect Print Servers - Administrator Guide

ENWW HP Jetdirect 802.11b Wireless Print Servers 273
Note If the Jetdirect embedded Web pages fail to display,
verify that the use of a Web proxy server is disabled.
See your Web browser help for instructions.
5. In the Jetdirect embedded Web pages, select the Networking
tab. On the Network Settings page, select the 802.11b tab.
6. Set the appropriate 802.11b wireless settings for your network:
■ Communication Mode (or wireless network topology)
■ Channel (Ad Hoc Mode only)
■ Network Name (SSID)
■ Authentication method
■ Static or dynamic encryption selections for your network
7. If your network requires IP configuration parameters for
network access (for example, due to DHCP or Host Access List
IP address restrictions), you should set those parameters now.
On the 802.11b configuration page, you can configure the
following TCP/IP settings:
■ IP Configuration Method
■ IP address
■ Subnet Mask
■ Default Gateway
If you change the IP address and click Apply, you may lose
communications with the print server. To reconnect, use the
new IP address.
8. When your HP Jetdirect print server has been configured with
your wireless network settings, click Apply.
Note By default, AppleTalk should be enabled (click the
AppleTalk tab for verification).
9. Verify that your printer can communicate on your network. See
To Verify the Wireless Network Connection
.