HP Jetdirect Print Servers - Administrator Guide

ENWW The HP Jetdirect Control Panel Menu 286
ENCRYPTION This menu is displayed if you selected Open
System, Shared Key, or EAP-MD5
authentication. Choose your static WEP key
encryption level:
128-BIT WEP: Selects 104/128-bit WEP.
64-BIT WEP: Selects 40/64-bit WEP.
NONE: (default) indicates that encryption is
not configured.
WEP encryption keys are configured using
the CONFIGURE KEYS menu.
CONFIGURE KEYS This menu appears only if 128-bit WEP or
64-bit WEP are selected. Use this menu to
assign the transmit key position and WEP key
values. Four key positions (key 1, 2, 3, or 4)
are available, but the selected key must
contain a valid WEP key value. If a valid WEP
key is not assigned, the first key found with a
valid key will be assigned.
TRANSMIT KEY: Select the active transmit
key position (key 1, 2, 3, 4).
ENTRY METHOD: Select the format for
entering WEP key values.
HEX: Enter values using hexadecimal
numbers (0 - 9, a - f, or A - F).
ALPHANUMERIC: Enter values using
the allowed alphanumeric ASCII
characters (0 - 9, a - z, A - Z).
KEY 1 through KEY 4: Enter a valid WEP key
value for each key position.
For hexadecimal entries, you must
enter 10 digits (for 40/64-bit encryption)
or 26 digits (for 104/128-bit encryption).
Hex digits are not case-sensitive.
For alphanumeric entries, enter 5
characters (for 40/64-bit encryption) or
13 characters (for 104/128-bit
encryption). Alphanumeric entries are
case-sensitive.
RESET 802.11b YES: Choose to reset the 802.11b wireless
parameters on the print server to
factory-default values. Parameter values
for other network protocols are not reset.
To view reset values, you must exit and
re-enter the control panel menu.
NO (default): 802.11b wireless parameters
are not reset.
Table C.2 HP Jetdirect Graphical Control Panel Menu (4 of 7)
Menu Item Options Description of settings