HP Jetdirect Print Servers - Administrator Guide

ENWW 38
3
TCP/IP Configuration
Introduction
To operate properly on a TCP/IP network, the HP Jetdirect print
server must be configured with valid TCP/IP network configuration
parameters, such as an IP address that is valid for your network.
For general information on TCP/IP networks, see Appendix A
.
Server-Based and Manual TCP/IP Configuration
When in a factory-default state and powered on, the HP Jetdirect
print server will try to obtain its TCP/IP configuration using a
server-based method, such as BOOTP/TFTP, DHCP/TFTP, or
RARP. These server-based methods are described later in this
chapter.
The print server may also be configured manually. Manual-based
tools include Telnet, a Web browser, the printer control panel, arp
and ping commands (when the default IP address is 192.0.0.192),
or SNMP-based management software. TCP/IP configuration
values assigned manually will be retained when powered off/on.
The print server can be reconfigured to use either server-based or
manual configuration of TCP/IP settings at any time.