HP Jetdirect Print Servers - Administrator Guide

ENWW TCP/IP Configuration 86
802.11 Wireless Diagnostics
Command Description
Current SSID (Read-only parameter) The network name (SSID) to which
the wireless print server connected.
Current Channel (Read-only parameter) The channel that the wireless print
server is currently using.
Signal Strength (Read-only parameter) The strength of the radio signal
received by the print server.
<blank>: No radio signal detected while the print server is
scanning.
No Signal: No radio signal detected on any channel.
Poor/Marginal/Good/Excellent: Indicates the detected
signal strength level.
Access Point Mac (Read-only parameter) The Media Access Control (MAC)
address of the Access Point used for Infrastructure mode
communications. For example,
00:a0:f8:38:7a:f7
specifies that the Access Point with MAC address
00a0f8387af7 was used for communicating on the network.
TCP/IP Main Settings
Command Description
host-name Alphanumeric string (up to 32 characters), to assign or
change the name of the network device. For example,
“host-name printer1” assigns the name “printer1” to the
device.
ip-config Specify the configuration method:
manual: The print server will wait for IP parameters using
manual tools (such as Telnet, embedded Web server,
control panel, installation/management software). Status
will be User Specified.
bootp: The print server will send BOOTP requests on the
network for dynamic IP configuration.
dhcp: The print server will send DHCP requests on the
network for dynamic IP configuration.
ip IP address for the print server, in dotted notation. For
example:
ip-config manual
ip 192.168.45.39
where ip-config specifies manual configuration and ip
manually sets the IP address 192.168.45.39 on the print
server.
Specifying 0.0.0.0 clears the IP address.
If you exit and save a new IP address, it must be specified
on the next Telnet connection.
Table 3.4 Telnet Commands and Parameters (6 of 18)