HP Jetdirect Print Servers - Administrator Guide

ENWW TCP/IP Configuration 97
usb-mode Specifies the communication mode over the USB port on the
HP Jetdirect print server.
● Auto (default): Automatically negotiates and sets the
highest communication mode possible for the attached
printer or device.
● MLC: (Multiple Logical Channels) An HP-proprietary
communication mode that allows multiple channels of
simultaneous print, scan and status communications.
● BIDIR: A standard connection that supports
bi-directional communications between the printer and
print server. The print server sends print data and
receives status from the printer.
● UNIDIR: A standard connection in which data is
transferred in one direction only (to the printer).
usb-speed (Read-only parameter, USB 2.0 products only) Specifies the
autonegotiated communication speed over the USB
connection between the HP Jetdirect print server and the
device.
● Full Speed: 12 Mbits/sec as specified in the USB v2.0
specifications, compatible with USB v1.1 specifications.
● Hi-Speed: 480 Mbits/sec for USB v2.0 devices only.
● Disconnected: The USB port is not connected.
status-page-lang Specifies the printer job language (PJL) that the print server
will use to send the Jetdirect configuration/status page to the
printer.
● Auto (default): The PDL is auto-detected when the print
server is powered on or after a cold-reset.
● PCL: Hewlett-Packard Printer Control Language
● ASCII: Standard ascii characters
● HPGL2: Hewlett-Packard Graphics Language (v2)
● PS: Postscript language
Support Settings
Command Description
Web JetAdmin URL (Read-only parameter) If HP Web Jetadmin discovers this
device, the URL to access HP Web Jetadmin will be
specified.
Web JetAdmin
Name
(Read-only parameter) If HP Web Jetadmin discovers this
device, the name of the HP Web Jetadmin host will be
specified (if known).
support-name Typically used to identify the name of a person to contact for
support of this device.
support-number Typically used to specify a phone or extension number to
call for support of this device.
Table 3.4 Telnet Commands and Parameters (17 of 18)