HP Color LaserJet 4550 printer family - Software Technical Reference

Network operating systems
HP Color LaserJet 4550 Software Technical Reference 153
8. In the left pane, if the old queue is listed, highlight the Queue name and select
Delete. To confirm the deletion, select OK. If the old queue is not listed, proceed to
the next step.
9. In the left pane, select the server where the new queue will be created.
10. Select the Create button.
11. Enter the queue name (Example: CLJ4550-1-B) and select OK
NOTE: The naming convention being used is as follows: Printer name,
dash, Unit number, dash, type of Queue (B for Bindery).
12. Select Yes to add this to the list of serviced queues.
13. Select OK.
14. The new queue should appear in the right pane. Select Next.
15. Verify that the queue’s IP, Gateway, and Sub-mask numbers are correct.
16. Select Next, then Finish, then OK to complete creation of a Bindery printer queue.
Build an NDS queue on a Novell server
1. Remove any previously built print queues.
2. Open Web JetAdmin and verify the IPX/SPX protocol is active.
NOTE: Protocol is indicated at the lower/bottom right corner of the
screen.
3. Right click the printer icon and select Modify.
4. Verify the printer name and description are correct, then select Next.
NOTE: The default icon shown will be Netware Directory Services; if it is
not, select it.
The convention used for this name is the printer name only. If
there are other units, a dash is included with the unit number
next. The description will always be the Spp number.
5. In NDS Tree name, select the tree where the server is located.
6. Verify or enter the correct Print Server Context.
7. Select the Operating Mode icon (no actual mode selection is necessary).
8. Select the Printer Queue icon.
9. Select the Change button.
10. If the old queue or Unknown Queue appears in the right pane, highlight the queue
name and select Remove. If not, continue to the next step.
11. If the old Queue is listed in the left pane, highlight the Queue name and select
Delete. To confirm the deletion, select OK. If it is not listed, proceed to the next step.
12. In the left pane, select the tree (not the server) where the NDS queue will be created.
13. Select the Create button.
14. Enter the queue name (Example: CLJ4550-1-NDS)