HP Color LaserJet 4550 printer family - Software Technical Reference

Network operating systems
HP Color LaserJet 4550 Software Technical Reference 154
NOTE: The naming convention being used is as follows: Printer name,
dash, unit number, dash, NDS (For the type of Queue you are
creating.
15. Verify the server and context are correct, then select OK.
16. To add this to the list of serviced queues, select Yes.
17. Select OK.
18. If the new queue appears, connected to the tree in the right pane, select Next.
19. Verify the IP, Gateway, and Sub mask numbers are correct.
20. Select Next, then Finish, then OK to complete the a NDS queue.
Build a queue with a new or reset JetDirect card
1. Open Web JetAdmin and select Device then New.
2. Select the correct MAC address of the printer JetDirect card.
3. Enter the Printer server name (this is the printer name) and the Spp description.
4. To create a Bindery Queue, see Build a Bindery queue on a Novell server complete the
installation.
5. To create an NDS Queue, see Build an NDS queue on a Novell server to complete the
installation.
Troubleshooting:
To correct errors concerning administrative rights, check server login type (verify the login
has the correct administrative rights). Refresh Web JetAdmin. If this does not eliminate
the error, login to the server again; reselect the tree, context and server to establish a
good link with the server.
If this does not eliminate the error, turn the printer off, hold down the green button and
turn the printer on again. The front panel will display “Cold Boot.” This will also reset the
JetDirect card; see Build a queue with a new or reset JetDirect card to proceed.
Building an NDPS Printer
Loading a driver to vend
1. Logon to the correct server with Administration rights.
2. If an NDPS Manager does not exist, create an NDPS Manager.
3. Double click on the Broker object.
4. Select the Resource Management button on the right side; it also might be labeled
(RMS).
5. Select the Add button.
6. Verify in the Current Resources field that no driver for the printer is loaded.
7. Select browse and navigate to the location of the driver .inf driver files, then select
the .inf file for the driver you want to load.
8. Select OK.
9. If a driver was already loaded, select Replace the current driver to load the new
driver.
10. After the driver has loaded, verify in the Current Resources field that the driver
loaded correctly.
11. Close the window.