HP PCL/PJL reference (PCL 5 Printer Language) - Technical Reference Manual Part II

20-18 The Vector Group EN
Figure 20-12
PU650,450; PD1000,450; Lift the pen, move to (650,450), place
the pen down, and draw a line to
(1000,450).
PU1000,100;
PD1000,1500, 2500,1500;
Lift the pen, move to (1000,100),
place the pen down, draw a line to
(1000,1500), then to (2500,1500).
AT3200,800,2500,100; Print an arc, starting at current pen
position (2500,1500), passing
through (3200,800) and ending at
(2500,100).
PU3200,900;PD; Lift the pen, move to (3200,900) and
set the pen down.
AT3300,800,3200,700; Print an arc, starting at the current
pen position, passing through
(3300,800) and ending at (3200,700).
PU3300,800; PD3500,800; Lift the pen, move to (3300,800), pen
down, and draw a line to (3500,800).
E
C
%ØA Enter the PCL mode.
E
C
E Send a reset to end the job and eject
the page.
Table 20-10 Example: Using the AT Command (continued)