HP PCL/PJL reference (PCL 5 Printer Language) - Technical Reference Manual Part II

EN Drawing Wedges 21-7
Figure 21-4 Drawing Wedges
The following example draws a wedge using the EW command. The
radius of the wedge is 600 plotter units, the wedge begins 90° from
the zero-degree reference point, and the wedge “sweeps” for 60°.
Note In the example plots, some reference points are added which are not
part of the example plot. These reference points are added for
clarification.
Table 21-5 Example: Drawing Wedges
?E Reset the printer.
?%0B Enter HP-GL/2 mode.
IN; Initialize HP-GL/2 mode.
SP1; Select pen number 1. Even though there is no
physical pen, the SP command must be used to
enable printing.
PA2500,3500; Specify absolute plotting and move to location
(2500,3500).