HP PCL/PJL reference (PCL 5 Printer Language) - Technical Reference Manual Part II

21-42 The Polygon Group EN
RR, Fill Rectangle Relative
This command defines and fills a rectangle using relative coordinates.
Use RR to fill rectangular shapes in drawings. (To outline a rectangle
using relative coordinates, use the ER command.)
RR X,Y[;]
The RR command defines and fills a rectangle using the current pen,
the current line and fill types, and relative coordinates. The RR
command includes an automatic pen down. After the command is
executed, the original pen location and up/down status are restored.
z X,Y Increments — Specify the corner of the rectangle that is
diagonally opposite from the current pen location, which is the
starting point of the rectangle. Coordinates are interpreted in
current units: as user-units when scaling is on; as plotter units
when scaling is off.
Note The following illustration shows the current pen location in the
lower-left corner and the command’s X,Y increments in the
upper-right corner. However, these points can be in any two
opposite corners depending on the coordinates used.
FT, Fill Type The Line and Fill Attributes Group
LT, Line Type
RF, Raster Fill Definition
Table 21-23 (continued)
Parameter Format Functional Range Default
X,Y increments current units -2
30
to 2
30
- 1 no
default