HP PCL/PJL reference (PCL 5 Printer Language) - Technical Reference Manual Part II

21-50 The Polygon Group EN
Figure 21-29
The center of the left circle is located at (4000,3000). The center of
the right circle is located at (4000,6000).
PW5; Select pen width of 5 units.
PM0; Enter polygon mode.
CI1000; Draw a circle with a radius of 1000 units.
PM2; Close polygon and exit polygon mode.
FT10,30; Select 30% shading fill type.
FP;EP; Fill then Edge polygon.
PU4000,3000; Select pen position (4000, 3000) for second
circle.
PM0; Enter polygon mode.
CI1000; Draw another circle with a radius of 1000 units.
PM2; Close polygon and exit polygon mode.
EP;FP; Edge then fill polygon (circle).
?%0A Enter the PCL mode.
?E Send a reset to end the job and eject the page.
Table 21-27 Example: (continued)