HP PCL/PJL reference (PCL 5 Printer Language) - Technical Reference Manual Part II

EN Introduction 22-1
22
The Line and Fill
Attributes Group
Introduction
The information in this chapter enables you to achieve the
following results in your HP-GL/2 applications:
z Enhance your drawings with various line types.
z Enhance your drawings with different fill types.
z Position fill type patterns.
The following commands are described in this chapter:
Table 22-1 The Line and Fill Attribute Commands
Command Summary
AC, Anchor Corner Specifies the starting point for
fill patterns.
FT, Fill Type Selects the pattern to use
when filling polygons.
LA, Line Attributes Specifies how line ends and
joins are shaped.
LT, Line Type Selects the line pattern to use
for drawing lines.
PW, Pen Width Specifies a new pen width.
RF, Raster Fill Definition Defines a pattern for use as
area fill.
SM, Symbol Mode Draws a symbol at each
coordinate location.
SP, Select Pen Selects a pen for plotting.