HP PCL/PJL reference (PCL 5 Printer Language) - Technical Reference Manual Part II

EN AD, Alternate Font Definition 23-19
z Value — Defines the properties of the characteristic specified by
the kind parameter.
Note When selecting fonts, the different characteristics (symbol set,
spacing, pitch, etc.) are prioritized as shown in the table above,
with symbol set being the highest priority and typeface being the
lowest. The font selection priority is the same for HP-GL/2 as for
PCL font selection. For more information about the priority of font
characteristics, see the “Font Selection by Characteristic” discussion
in Chapter 8.
Note To avoid duplication of many pages of tables, the tables listing the
kind parameters (symbol set, spacing, typeface, etc.) are located
with the description of the SD (Standard Font Description) command.
The following example shows the command used to designate a
30-point CG Times Bold Italic font in the ASCII symbol set (use the
Select Alternate Font (SA) command to select this font after it is
designated):
Note that the pitch parameter is missing in the above command
because the designated font is proportionally spaced.
6 Stroke Weight 0 medium
7 Typeface 48 Stick (fixed vector)
Table 23-6 (continued)
Table 23-7
Related Commands Group
FI, Select Primary Font The Character Group
FN, Select Secondary Font
LB, Label