HP PCL/PJL reference (PCL 5 Printer Language) - Technical Reference Manual Part II

EN Job Control 24-3
Job Control
Printer Reset
Hewlett-Packard strongly recommends the use of both the
E
C
E
command and the
E
C
%–12345X command (Universal Exit
Language/Start of PJL — also referred to as the UEL Command)
at the beginning and end of each job. (The order of these commands
is critical; refer to Table 24-1 for an example.) This allows the next job
to start with the default settings as a known base. Starting with the
default environment at the beginning of each print job eliminates the
need to set every feature each time a job is run.
Note The UEL Command (
E
C
%–12345X) has the same effect as the
E
C
E
command, and also enters PJL Mode of operation for printers that
support PJL. The
E
C
E command should be included to ensure
backward compatibility (the UEL command is ignored if received by a
printer that does not support PJL).
Do not perform a printer reset within a job.
Table 24-1 Structure of a Typical Job
E
C
%–12345X UEL Command (exit language).
E
C
E Printer Reset Command.
Preamble Job Control Commands.
Page 1 Page Control Commands.
Data
M M
Page n Page Control
1
Commands.
1. If a number of consecutive pages within a job have the same format (such as
margins, VMI, HMI, etc.), the associated page control commands only need to be
sent once for that group of pages.
Data.
E
C
E Printer Reset Command.
E
C
%–12345X UEL Command (exit language).