HP PCL/PJL reference - Printer Job Language Technical Reference Manual

EN Product-Specific Feature Support A-57
HP LaserJet 5Si Mopier Comments
PJL commands are used to specify the destination bin and control
printer functions such as stapling and collating multiple copies.
Specifying the Output Bin
Documents are sent to specific output bins using the
@PJL SET OUTBIN command. The HP LaserJet 5Si Mopier bin
definitions are as follows:
Stapling Documents
To staple a document, include the following PJL command in the PJL
header at the beginning of the job (see the example on the following
page):
@@PJL SET FINISH=STAPLE
To staple the output using this command, the printer automatically
determines which bin is the stapling bin, so the output bin does not
need to be specified using the @PJL SET OUTBIN command. The
printer uses the EOJ command to determine the end of job so that the
job can be stapled correctly.
Note Future printers may enable stapling using a different command
sequence.
Bin Description OUTBIN Variable Name
Engine face-down bin UPPER
High Capacity Output (HCO)
face-up bin
OPTIONALOUTBIN1
Stapling bin (in mailbox mode) OPTIONALOUTBIN7
Stapling bin (in stacker or job-
separator modes)
OPTIONALOUTBIN3
First non-stapling bin in mailbox
mode (only bin in stacker and
job-separator modes)
OPTIONALOUTBIN2
Last non-stapling bin (bottom bin in
mailbox mode)
OPTIONALOUTBIN6