HP Jetdirect Print Servers - Administrator Guide

ENWW TCP/IP Configuration 94
trap-dest Enters a host IP address into the HP Jetdirect print server’s
SNMP trap destination list. The command format is:
trap-dest:
ip-address [community name] [port number]
The default community name is ‘public’; the default SNMP
port number is ‘162’. The port number cannot be specified
without a community name.
To delete the table, use ‘trap-dest: 0’.
If the list is empty, the print server does not send SNMP
traps. The list may contain up to three entries. The default
SNMP Trap Destination List is empty. To receive SNMP
traps, the systems listed on the SNMP trap destination list
must have a trap daemon to listen to those traps.
IPX/SPX Settings
Command Description
ipx-config Enables or disables IPX/SPX protocol operation on the print
server. 0 disables, 1 (default) enables. For example,
ipx-config 0 will disable IPX/SPX operation.
ipx-unitname (Print Server Name) A user-assigned alphanumeric name
assigned to the print server (31 characters maximum). By
default, the name will be NPIxxxxxx, where xxxxxx are the
last six digits of the LAN hardware address.
Address (Read-only parameter) Identifies the IPX network and node
numbers detected on the network, in the form
NNNNNNN:hhhhhhhh (hexadecimal), where NNNNNNNN
is the network number and hhhhhhhh is the LAN hardware
address of the print server.
ipx-frametype Specifies the IPX frame type settings available for your print
server model: AUTO (default), EN_SNAP, EN_8022,
EN_8023, EN_II, TR_8022, TR_SNAP. For more
information, see Chapter 9
.
ipx-sapinterval Specifies the time interval (1 to 3600 seconds) that the
HP Jetdirect print server waits between Service Advertising
Protocol (SAP) broadcasts on the network. The default is
60 seconds. 0 disables SAP broadcasts.
ipx-nds-tree An alphanumeric string, up to 31 characters, that specifies
the NDS tree name for the print server.
ipx-nds-context An alphanumeric string, up to 256 characters, that specifies
the NDS context for the HP Jetdirect print server.
ipx-job-poll Specifies the time interval (1 to 255 seconds) that the
HP Jetdirect print server will wait to check for print jobs in
a print queue. The default is 2 seconds.
ipx-banner Enables or disables printing an IPX banner page through
Printer Job Language (PJL). 0 disables banner pages. 1
(default) enables banner pages.
ipx-eoj Enables or disables IPX end-of-job notification through PJL.
0 disables, 1 (default) enables.
Table 3.4 Telnet Commands and Parameters (14 of 18)