HP Color LaserJet CP6015 Series - User Guide

6. If you are adding a DIMM to slot 2, locate the hard disk release tab on the bottom of the formatter

board, and then pinch the tab to release the end of the hard disk assembly.

7. Rotate the end of the hard disk assembly upward until you can disengage the hinge tabs at the

other end.

8. Leaving the hard disk assembly plugged in, lay it to the side to allow space to add or replace the

DIMM in slot 2.

9. To replace a DIMM that is currently installed in either slot, spread the latches apart on each side

of the DIMM, lift the DIMM up at an angle, and pull it out.

XOXOXO

XOXOXOXOXOXO

XOXO

XOXOXOXOXO

XOXOXOXOXOXO

XOXO

XOXOXO

XOXOXOXO

XOXO

XOXOXO

10. Remove the new DIMM from the antistatic package. Locate the alignment notch on the bottom

edge of the DIMM.

ENWW Replace supplies 159