HP Color LaserJet CP6015 Series - User Guide

Item Sub-item Values Description
DISCHARGE MODE NORMAL (default)
ON
Select ON if you are seeing clumps of toner or
toner spatter on print jobs. These problems can
occur in low-temperature and low-humidity
environments, with lightweight or thin paper. The
problems might happen more frequently with
duplex jobs.
PRINT MODES AUTO SENSE MODE
(default)
NORMAL
TRANSPARENCY
MODE
<ADDITIONAL PRINT
MODES>
Allows you to change the print mode for non-HP
paper types, which can affect print quality.
When AUTO SENSE MODE is enabled, the
product media sensor picks the best print mode.
RESTORE MODES Use this feature to return all paper type-mode
settings to the factory-default settings.
OPTIMIZE PAPER CURL NORMAL (default)
REDUCED
To help reduce paper curl, set this option to
REDUCED. This decreases full speed to 10 PPM
(instead of 40 ppm) and 3/4 speed to 7.5 ppm
(instead of 30 ppm).
PRE-ROTATION OFF (default)
ON
Set this feature to ON if horizontal streaks appear
on pages. Using this feature increases the warm-
up time for the product.
FUSER TEMP NORMAL (default)
ALTERNATE 1
ALTERNATE 2
ALTERNATE 3
Reduces the temperature of the fuser to prevent a
hot offset.
If you are seeing a faint image of the page repeated
at the bottom of the page or on the following page,
you should first make sure the Paper Type and
Print Mode settings are correct for the type of
paper you are using. If you continue to see ghost
images on your print jobs, set the Fuser Temp
feature to one of the Alternate settings. Try the
Alternate 1 setting first and see if it solves the
problem. If you continue to see the problem, try
Alternate 2 and then Alternate 3. With the Alternate
2 and Alternate 3 settings you may see an extra
delay between jobs.
TRAY 1 NORMAL (default)
ALTERNATE
If you are seeing marks on the back side of the
paper when printing from Tray 1, set the mode to
ALTERNATE. This increases the frequency of the
cleaning cycle.
GLOSS MODE NORMAL (default)
HIGH
Chosen when stable high gloss is required.
Set this feature to HIGH for glossy print jobs, such
as photos, if you notice the gloss finish decreasing
after the first page is printed. This setting reduces
the performance for all paper types.
LIGHT MEDIA AUTO (default)
ON
Prevents the fuser from wrapping with lightweight
paper.
Set this feature to ON if you are frequently seeing
Fuser Delay Jam or Fuser Wrap Jam messages,
24 Chapter 2 Control panel ENWW