HP Color LaserJet CP6015 Series - User Guide

Item Sub-item Values Description
causes minimal impact to the first-
page-out time.
If SAVE MOST ENERGY is
selected, power to the fuser is
turned off after each job. This
causes the most impact to the first-
page-out time.
DISPLAY BRIGHTNESS Range is 1 through 10. Sets the brightness of the control
panel display. The default is 5.
PERSONALITY AUTO
PCL
PDF
PS
Sets the default personality to
automatic switching, PCL, PDF, or
PS modes. The default is AUTO.
CLEARABLE WARNINGS JOB
ON
Sets whether a warning is cleared
on the control panel or when
another job is sent. The default is
ON.
AUTO CONTINUE OFF
ON
Determines product behavior
when the system generates an
Auto Continuable error. The
default is ON.
REPLACE SUPPLIES STOP AT LOW
STOP AT OUT
OVERRIDE AT OUT 1
OVERRIDE AT OUT 2
Sets product behavior when a
cartridge is low. The default is
STOP AT LOW. This option allows
the product to continue printing
until a color supply is exhausted.
When the product is set to STOP
AT OUT, printing pauses until the
color supply is replaced.
The product displays an “Order
supplies” message when a supply
is running low and a “Replace
supplies” message when a supply
has been depleted. To ensure
optimal print quality, HP
recommends replacing a supply
when the “Replace supplies”
message is displayed. Replacing
the supply at this point can help
prevent waste of media or other
supplies when one supply begins
producing poor print quality. The
Override options allow the product
to continue using color supplies,
such as print cartridges, the image
drum, the roller kit, and the image
fuser kit, that have reached their
recommended replacement
points.
ENWW Configure device menu 31