HP Color LaserJet CP6015 Series - User Guide
Item Sub-item Values Description
Select YES to choose this test, or NO to not choose it.
DATA PATH TEST This test helps to identify data path and corruption
problems on an HP postscript level 3 emulation
product. It sends a predefined PS file to the product,
However, the test is paperless; the file will not print.
Select YES to choose this test, or NO to not choose it.
SELECT ALL TESTS Select this item to run all the embedded tests. Select
YES to run all tests, or select NO to not run all tests.
EXECUTION TIME [H] Use this item to specify the length of time (in hours) that
an embedded test will be run. You can select a value
from 1 to 60 hours. If you select zero (0), the test runs
indefinitely until an error occurs or the product is turned
off.
Data gathered from the HTTP, SNMP, and Data Path
tests is printed after the tests have completed.
EXECUTE NO*: Do not initiate the selected tests.
YES: Initiate the selected tests.
PING TEST This test is used to check network communications.
This test sends link-level packets to a remote network
host, then waits for an appropriate response.
DEST TYPE Specify whether the target device is an IPv4 or IPv6
node.
DEST IPV4 Type the IPv4 address.
DEST IPV6 Type the IPv6 address.
PACKET SIZE Specify the size of each packet, in bytes, to be sent to
the remote host. The minimum is 64 (default) and the
maximum is 2048.
TIMEOUT Specify the length of time, in seconds, to wait for a
response from the remote host. The default is 1 and
the maximum is 100.
COUNT Specify the number of ping test packets to send for this
test. Select a value from 1 to 100. To configure the test
to run continuously, select 0.
PRINT RESULTS If the ping test was not set for continuous operation,
you can choose to print the test results. Select YES to
print results. If you select NO (default), results are not
printed.
EXECUTE Specify whether to initiate the ping test. Select YES to
initiate the test, or NO to not run the test.
PING RESULTS Use this item to view the ping test status and results
using the control panel display.
PACKETS SENT Shows the number of packets (0 - 65535) sent to the
remote host since the most recent test was initiated or
completed.
Table 2-1 Embedded Jetdirect and EIO <X> Jetdirect menus (continued)
40 Chapter 2 Control panel ENWW