HP Color LaserJet CP6015 Series - User Guide

Item Sub-item Values Description
PACKETS RECEIVED Shows the number of packets (0 - 65535) received from
the remote host since the most recent test was initiated
or completed.
PERCENT LOST Shows the percent of ping test packets that were sent
with no response from the remote host since the most
recent test was initiated or completed.
RTT MIN Shows the minimum detected roundtrip- time (RTT),
from 0 to 4096 milliseconds, for packet transmission
and response.
RTT MAX Shows the maximum detected roundtrip- time (RTT),
from 0 to 4096 milliseconds, for packet transmission
and response.
RTT AVERAGE Shows the average round-trip-time (RTT), from 0 to
4096 milliseconds, for packet transmission and
response.
PING IN PROGRESS Shows whether a ping test is in progress. YES
indicates a test in progress, and NO indicates that a
test completed or was not run.
REFRESH When viewing the ping test results, this item updates
the ping test data with current results. Select YES to
update the data, or NO to maintain the existing data.
However, a refresh automatically occurs when the
menu times out or you manually return to the main
menu.
LINK SPEED AUTO
10T HALF: 10 Mbps, half-
duplex operation.
10T FULL: 10 Mbps, full-
duplex operation.
100TX HALF: 100 Mbps,
half-duplex operation.
100TX FULL: 100 Mbps,
full-duplex operation.
100TX AUTO: Limits
auto-negotiation to a
maximum link speed of
100 Mbps.
1000TX FULL: 1000
Mbps, full-duplex
operation.
The link speed and communication mode of the print
server must match the network. The available settings
depend on the product and installed print server. Select
one of the following link configuration settings:
CAUTION: If you change the link setting, network
communications with the print server and network
device might be lost.
AUTO*: The print server uses auto-negotiation to
configure itself with the highest link speed and
communication mode allowed. If auto-negotiation fails,
either 100TX HALF or 10TX HALF is set depending on
the detected link speed of the hub/switch port. (A
1000T half-duplex selection is not supported.)
PRINT PROTOCOLS Use this item to print a page that lists the configuration
of the following protocols: IPX/SPX, Novell NetWare,
AppleTalk, DLC/LLC.
Resets menu
The RESETS menu allows you to reset factory settings, disable and enable sleep mode, and update
the product after new supplies are installed.
Table 2-1 Embedded Jetdirect and EIO <X> Jetdirect menus (continued)
ENWW Configure device menu 41