HP EVA-to-3PAR Online Import Migration Guide (T5494-96606)

B Consolidated migration procedures
Migrating a host
NOTE: If you are migrating a non-Windows host, make sure you have zoned the host to the
3PAR destination storage system before performing the migration. For more information, see
“Zoning a host to the destination 3PAR storage system” (page 12).
Selecting the host and destination
1. In Command View, select the Storage Systems point of view.
2. Select the HP EVA to 3PAR StoreServ Online Import tab.
3. In the left navigation pane, select a host.
You can select a host folder, an individual host, or a user defined host folder.
4. Click Add Migration.
The Add Migration from a Host Selection wizard runs.
5. Read the information on the Introduction screen, then click Next.
The Select explicit migration source screen is displayed.
6. Select the host that will be the source, then click Next.
The Confirm Explicit and Implicit Migration Sources screen is displayed.
TIP: If the number of objects included in the migration is too large, you can cancel the
migration at this point.
7. Check the implicit and explicit host and virtual disk selections to ensure they are ready for
migration, then click Next.
The Confirm Your Migration Destination screen is displayed.
NOTE: If any object selected for migration is not ready for data migration, the appropriate
status is displayed in the Migration OK? column and the Next button is disabled. In this case,
click Export Selections to save the selections information to a file for troubleshooting. Then
click Cancel to stop the migration wizard. Using the selections information saved, correct the
problem and then run the migration wizard again.
8. Check the 3PAR Destination Storage System to ensure it is ready for migration, then click
Next.
The Configure Destination Volumes screen is displayed.
NOTE: If the Migration OK? status is not OK, the tool tip provides information on why the
migration cannot be performed until the necessary action is taken.
9. Set the Destination Virtual Volume Attributes.
a. Set the Configuration to Set individually.
b. Select the desired Destination Provisioning for the destination virtual volume.
c. Select the desired Destination Common Provisioning Group (CPG) for the destination
virtual volume.
d. If you want to use these settings for all the virtual volumes, set the Configuration to Set all
the same. If you want to use different settings for each volume, repeat the steps for each
volume.
10. Click Next.
The Summary screen is displayed.
42 Consolidated migration procedures