HP StoreEver Command View for Tape Libraries (CVTL) v. 3.7 and Interface Manager Firmware v I274 Release Notes

• Fixes for numerous CLI formatting errors.
• Fixed a potential issue where a “Failed to Migrate Drive” error could be reported when using the
Drive Update Wizard to migrate a LTO1, LTO2, or LTO3 drive to a LTO4 or LTO5 drive. The
error was most likely to occur on a partitioned library.
• Corrected handling of the restore config operation. Now, a config file created up to two major
revisions prior to the current firmware can be restored.
• Fixed an issue where collecting a support ticket from an LTO3 drive could result in a blank ticket.
• Fixed an issue so that it is no longer possible to assign 192.168.2.xxx IP addresses to EML
libraries; this IP address range is not compatible with hardware in an EML library.
• Fixed an issue so it is no longer possible to set the IP broadcast address on EML libraries.
• Fixed an issue where switching between IPV6 and IPV4 in a single operation, on an EML library,
the OCP would not show the IPV4 address.
• When a SNMP Trap String is modified in the CVTL GUI, the new Trap String now takes effect
immediately.
• SNMP read requests to unsupported MIB identifiers no longer cause the SNMP log file to grow.
• SNMP reads of the standard system MIB now return correct values for host name, system location,
and contact.
• The CLI command Show Library Topology now reports correct drive information.
• ESL libraries will now automatically trigger cleaning tape tickets.
• ESL and EML event codes are now sent as SNMP Traps, for Remote Support.
• When performing a manual migration from a SKM encryption server to an eSKM encryption
server, performing a ‘Validate SKM Connectivity’ operation will update the displayed key manager
type.
Version 2.8.00
• Command View TL no longer calculates read margins on small transfer sizes because the data is
not accurate.
• Command View TL now requires Java Runtime Environment (JRE) version 1.6.0, Update 24, also
known as “6.0”.
• The TapeAssure Overview page now shows the following message for libraries that are I250 or
lower: The libraries need a firmware upgrade to be TapeAssure
compatible...
• Fixed an issue on the Command View TL Launcher where the ESL Library had an EML name and
serial number.
• Fixed an issue on the Tape Properties page where the Drive Serial Number was labeled as the
Library Serial Number.
• Fixed a case when Command View TL was not displaying drive support tickets if a cleaning tape
was in the drive.
Version 2.7.00
• On rare occurrences, connectivity to LTO4 or LTO5 drives could be lost following a reboot of the
Interface Manager, library, or the individual drive. This loss of connectivity caused the drives to
have red health status. This item is fixed.
• In Command View TL version 2.6, Interface Controller replacements were not correctly detected
and acted upon. The workaround at that time was to restore defaults on the Interface Manager
and setup the library again. This item is fixed.
Previous Version Fixes 17