HP StoreEver Command View for Tape Libraries (CVTL) v. 3.7 and Interface Manager Firmware v I274 Release Notes

• Secure Manager feature remains green despite disconnecting a drive If a drive fibre cable is
disconnected from an interface controller, Command View for Tape Libraries was not detecting
that the management path had been lost. This item has been fixed.
• Restoring a 2.32 saved configuration in 2.50 times out Due to an inter-process communication
failure within the Interface Manager, restoring a previously saved configuration could timeout.
This item has been fixed.
• Reboot drive dialog not being updated during drive reboot When rebooting an LTO4 drive from
the Command View TL user interface, the text and progress meter within the reboot dialog box
never change. However, the drive did successfully reboot. This item has been fixed.
• Command View for Tape Libraries service unexpectedly restarting The Command View for Tape
Libraries service might restart on a management station if the host was being starved for CPU
resources. This item has been fixed.
• "No Policy Found" error after fixing policy on SKM After fixing a bad policy name on an SKM,
the library using that policy still reported “No Policy Found for partition” after running an SKM
connectivity check. This item has been fixed.
• Postgre database failed to install during Command View for Tape Libraries installation If the host
where Command View for Tape Libraries was being installed already had a postgre database
installed, and a different user has installed the postgre database, then the Command View for
Tape Libraries installation could fail. This item has been fixed.
• Restoring system defaults does not reset SNMP configuration SNMP settings could be retained if
the Interface Manager was restored to factory defaults, even if the ‘Retain SNMP Settings’ option
was not selected. This item has been fixed.
• MSL libraries will not add to the Command View for Tape Libraries launcher if https is enabled If
https was enabled on an MSL library, then the MSL library could not be added to the Command
View for Tape Libraries launcher. This item has been fixed.
• TapeAssure stops receiving support tickets after 5 failures In the Interface Manager could not
communicate with tape drives on the internal network, TapeAssure data collection would stop
until the Interface Manager was rebooted. This item has been fixed.
• Uninstalling Command View for Tape Libraries deletes folder if non-default destination folder is
used If Command View for Tape Libraries is installed into a folder other than the default destination
folder it would delete that folder and all of its contents when it was uninstalled. This item has been
fixed.
• Creating new host(s) via command line interface does not inherit custom map settings When using
Command View for Tape Libraries with a Basic Secure Manager license and a custom map had
been defined, then creating new hosts with the command line interface would not inherit the
custom map settings. This did not apply to Advanced Secure Manager licenses. This item has
been fixed.
• Blank entry for email field causes SKM enrollment hang Blank email fields in the SKM CA certificate
caused SKM enrollment process to hang at last step of the wizard in Command View for Tape
Libraries. This item has been fixed.
• Upgrade of Command View for Tape Libraries from C: drive to non C: drive fails to start Command
View for Tape Libraries service Assuming that Command View for Tape Libraries had been installed
to its default location on the C: drive, if Command View for Tape Libraries was upgraded and a
new location was selected for the upgrade, an installation failure could occur. This item has been
fixed.
• Reboot of 4 Gbps Interface controllers can potentially timeout The default timeout of 5 minutes
waiting for 4 Gbps interface controller cards could be too short. The default timeout has been
increased.
• Support ticket viewer not displaying some headings Certain sub-sections of a support ticket did
not have a title when viewing the ticket with the support ticket viewer. This item has been fixed.
20 Previous Version Fixes