HP StoreEver Command View for Tape Libraries (CVTL) v. 3.7 and Interface Manager Firmware v I274 Release Notes

• SNMP trap IP addresses wrong on ESL E—Series Tape Libraries All IP address on the traps were
10.0.0.89 or 192.168.0.89 instead of the Public address of the library. In I260 this has changed
to the public IP address.
• SNMP management information base (MIB) command system.sysDescr.0 returning value of Linux
instead of correct library type This caused issues during auto discover of devices. In I260 this
command is set to return the library type instead.
• Service login has issues when the operation needs to create a new directory Some of the debugging
tools were failing when the service login was used. This item has been fixed.
• Non-HP tape drives, or drives with the wrong Hardware Personality were not identified in Command
View for Tape Libraries A new alert will be added to the alert log to indicate that a drive with the
wrong Hardware Personality, shown in the drive Properties dialog box, is in the library so that it
can be removed.
• Drive properties does not display the Hardware Personality type or the firmware revision of a
drive The drive properties window did not display the Hardware Personality type or the firmware
revision of the drive. This item has been fixed.
• Interface Manager downloads might hang indefinitely and continue to hang even after a reboot
If the Interface Manager flash had gone to a read only state it could get stuck in this condition
until the flash was replaced. In this situation, the download no longer hangs, but the flash still
must be replaced.
• Dual networked hosts sometimes have operation timeout failures Firmware has been modified to
avoid timeout problems in this situation.
• Out Of Memory errors in the dmesg section of the Interface Manager support ticket If the Interface
Manager was shutting down application processes, out-of-memory errors were recorded in the
dmesg section of the Interface Manager support ticket. This item has been fixed.
• Sync SecureManager fails with the IP address not found The command line interface command
'sync securemanager' fails with the IP address not found. This item has been fixed.
• Command View for Tape Libraries version 2.5 has a dependency on a Windows local user account
A dependency on a local user account for the TapeAssure feature has been removed. The user
account was required for Command View for Tape Libraries 2.5.00, but is not required for version
2.6.00.
• Command View for Tape Libraries service monitor was failing to start or was being restarted in
the middle of operations If the server hosting Command View for Tape Libraries experienced
heavy network traffic from other applications, the Command View for Tape Libraries service
monitor would assume the service was stopped and restart it. If this happened during an operational
command (for example, saving a configuration or moving media) the operation command would
timeout. The timeout interval for startup and monitoring of the Command View for Tape Libraries
service monitor and the Command View Java runtime memory are increased in this release.
• For EML E-Series Tape Libraries, “show lib cli” does not work after replacement of the library
Robotics Controller This item has been fixed.
Version 2.5.00
• Drive clean request not reported in Command View for Tape Libraries Alert Log When a tape
drive needs to be cleaned, this status now displays with the drive health status on the Status page
of the Command View TL user interface.
• Inventory in user interfaces not refreshed after accessing load port or library front door The library
inventory presented by either the Command View TL user interface or the Interface Manager
command line interface is now updated whenever a load port or library front door is accessed.
Previous Version Fixes 21