HP StoreEver Command View for Tape Libraries (CVTL) v. 3.7 and Interface Manager Firmware v I274 Release Notes

Interface Manager database “malformed”
Symptom: The error An error occurred while updating data. Please retry the
operation. is followed by SQLite error 11: database disk image is malformed.
Workaround: Contact HP Support.
Found in version: 2.7.00
LTO3 cleaning cartridge information is not saved
Symptom: Most LTO3 drives are unable to save cleaning cartridge information. The LTO3 drive
hardware revision that is capable of saving cleaning cartridge information may be identified by a
firmware revision starting with "U".
Workaround: Install an LTO3 drive with a firmware revision that begins with “U”.
Found in version: 2.7.00
After a firmware download, the 8 Gb Fibre Channel link disconnects
Symptom: After downloading firmware to a drive, some switches will lose the link to the drive.
Workaround: Make sure that your 8Gb Fibre Channel switch has the latest firmware, as recent switch
fixes have been introduced. If the problem persists, either 1) reboot the drive again with Command
View TL, or 2) unplug the fibre channel cable at the switch, then plug it back in.
Found in version: 2.7.00
Modifying system network card configuration causes “NOT BOUND IN REGISTRY”
errors
Symptom: On the management station, if you disable the active network card and enable a different
network card, Command View TL will display “NOT BOUND IN REGISTRY” errors.
Workaround: Restart the Command View TL service after the network cards have been altered.
Found in version: 2.7.00
Java 6, update 20 warning messages for unsigned code
Symptom: Java 6, update 20 and higher will prompt the user regarding unsigned code. The user must
accept and run the unsigned code so that Command View TL will function properly. This is not an issue
with previous releases of Java.
Workaround: Accept and run the unsigned code, when you are working in Java 6, update 20 or
higher.
Found in version: 2.7.00 and 2.8.00
Secure Manager will not synchronize when there are more than 255 hosts
Symptom: If there are more than 225 stale hosts—hosts that were on the SAN at one point, but are
no longer present—Secure Manager can not synchronize.
Workaround: Reboot any LTO4 and LTO5 devices in the library.
Found in version: 2.7.00
The operation restore system defaults fails when restoring advanced LTO drives
Symptom: When restoring an advanced LTO tape drive (LTO4 or LTO5), the operation restore system
defaults might fail.
Workaround: Retry the operation. If it fails a second time, contact HP support.
Found in version: 2.7.00
Workarounds 29