HP Interface Manager and Command View for Tape Libraries 3.7 User Guide

move media
Description Moves media between drives, slots, and mail slots.
Syntax move media destination source
Availability All users and mode
Operands The media locations are specified using a
media location type code and the logical
address of the location. For instance:
destination, source
• Dn—Drive at logical address n
• Mn—Mailslot at logical address n
• Sn—Storage slot at logical address n
Examples To move media from storage slot 10 to drive 1:
/>move media S10 D1
To move media from drive 1 to mail slot 1:
/>move media D1 M1
To move media from mail slot 1 to storage slot 10:
/>move media M1 S10
See also show media
reboot interface
Description Reboots one or more interfaces. After entering this command, you are prompted
to input whether you are sure you want to reboot the interfaces.
CAUTION: Ensure that an interface is not involved in any backup operations
before rebooting it.
Syntax reboot interface interface_num [force]
Availability All users and manual mode only
Operands Specify the interface number. All of the interfaces may
be rebooted by specifying all for this operand. This
operand is required.
interface_num
[force] Specify force to skip the prompt asking if you are sure
you want to reboot the interface(s). This operand is
optional.
Examples To reboot interface 1:
/>reboot interface 1
Caution: Rebooting interfaces could take up to XX seconds and will
terminate all backup operations involving the rebooting
interfaces.
Do you really want to reboot the interface(s) (y/n)? y
Rebooting interfaces..done
To reboot all interfaces, skipping the reboot prompt:
/>reboot interface all force
Rebooting interfaces..done
See also reboot library
reboot mgmt
196 CLI Command Reference