HP Interface Manager and Command View for Tape Libraries 3.7 User Guide

Searching for replacement candidate for missing Interface Controller 1 out of 1
(100000e002025e2f)
Finished searching for replacement hardware
Calling GetValidReplacementIndices
IFC # Missing IFC WWN Replacement IFC WWN Status
----- -------------------- -------------------- -----------------
1 100000e002025e2f 100000e00202a627 Ready to configure
Select 1 or more IFCs to replace, using the index in column 1. If more than
one IFC is selected, separate the indices with spaces: 1 2 4. Type 'all' to
reconfigure all cards with the identified replacement. Type 'R' to refresh
the list (for instance, after correcting a cabling error). Type 'Q' to quit
this wizard without completing the operation.
>> 1
FRU replacement has begun.
Initializing
Activity: Initiating Restore
Initializing
Activity: Initiating Restore
Activity: Restoration of connection settings to IFC 100000e002025e2f completed
successfully; Waiting for IFC to reboot to finalize settings
Initializing
Activity: Initiating Restore
Activity: Restoration of connection settings to IFC 100000e002025e2f completed
successfully; Waiting for IFC to reboot to finalize settings
Activity: Restoration of port settings to IFC 100000e002025e2f completed
successfully
Initializing
Activity: Initiating Restore
Activity: Restoration of connection settings to IFC 100000e002025e2f completed
successfully; Waiting for IFC to reboot to finalize settings
Activity: Restoration of port settings to IFC 100000e002025e2f completed
successfully
IFC Replacement operation failed - Synch failed .
IFC Replacement operation failed - Synch failed.
Activity: Initiating Restore
Activity: Restoration of connection settings to IFC 100000e002025e2f completed
successfully; Waiting for IFC to reboot to finalize settings
Activity: Restoration of port settings to IFC 100000e002025e2f completed
successfully
FRU replacement has completed.
You may now connect the FRUs that were successfully replaced to the hosts.
See also None
restore interface defaults
Description Restores interfaces to their factory defaults.
CAUTION: Using this command forces a reboot of the interface. Ensure that
no backup jobs are in progress before running this command.
Syntax restore interface defaults interface_num
Availability All users and manual mode only
Operands Specify the interface number that will be restored to
factory defaults. All of the interfaces may be restored to
interface_num
factory defaults by specifying all for this operand. This
operand is required.
Examples To restore the factory defaults on interface 1:
/>restore interface defaults 1
Committing configuration...done
The interface(s) must be rebooted before the new configuration
will take effect.
To restore the factory defaults on all interfaces:
/>restore interface defaults all
Committing configuration… done
The interfaces(s) must be rebooted before the new configuration
will take effect.
See also restore system defaults
restore interface defaults 199