HP Interface Manager and Command View for Tape Libraries 3.7 User Guide

Table 3 Management station to Interface Manager card network ports
PurposePort number
TCP inbound8099
TCP SSL outbound18098
TCP bidirectional in Command View TL 2.8.00 or lower8098
By configuring the firewall to enable communication through these ports, the management
station can be on the other side of the firewall from the Interface manager.
See your firewall documentation for instructions on configuring network access.
Table 4 Interface Manger uses this port for SNMP
PurposePort number
UDP SNMP from SKM bidirectional161
Servers intending to receive SNMP traps will need to have this port open.
Table 5 Interface Manger uses this port for Network Time Protocol (NTP)
PurposePort number
TCP and UDP bidirectional123
Servers intending to use NTP will need to have this port open.
HP recommends that an Secure Key Manager (SKM) or Enterprise Secure Key Manager (ESKM)
appliance (node) use the following network ports to communicate with the SKM or ESKM
management user interface, or for SKM or ESKM communication to other devices. All ports
are TCP and SSL capable.
Table 6 SKM or ESKM network ports
PurposePort number
SSH login to SKM bidirectional22
SNMP from SKM bidirectional161
Interface Manager login to SKM) bidirectional9000
FIPS status server from SKM bidirectional9081
SKM networking bidirectional9001
Web login to SKM bidirectional9443
Table 7 SMTP port
PurposePort number
SMTP to send e-mails bidirectional25
Table 8 LTT service ports
PurposePort number
LTT Service requests from clients7999-8099
Used for SSH tunneling7011-7027
Used for LTT Notification server7000-7010
20 Command View TL GUI