HP Interface Manager and Command View for Tape Libraries 3.7 User Guide

the new name is applied, and all resource mapping pools to which the host
had been added are updated to reflect the new name.
Syntax set host name index host_name
Availability All users and modes
Operands Specify the number of the host to be named.index
host_name Specify the name of the host. The host name may contain
letters, numbers, and '_' characters. The maximum length for
a host name is 19 characters. This operand is required.
Examples To set the name of host 1 to myhost1:
/>set host name 1 my_host1
Committing configuration...done
See also show host name
set inet ftp
Description Enables or disables the FTP/SFTP service.
Syntax set inet ftp [on] | [off]
Availability Admin user and all modes
Operands Enables the FTP/SFTP service.on
off Disables the FTP/SFTP service.
Examples To disable the FTP/SFTP service:
/>set inet ftp off
Committing configuration...done
See also set inet telnet
set inet telnet
Description Enables or disables the Telnet service.
NOTE: If the Telnet service is disabled, you can only re-enable it by
connecting with a serial cable to the Interface Manager.
Syntax set inet telnet [on] | [off]
Availability Admin user and all modes
Operands Enables the Telnet service.on
off Disables the Telnet service.
Examples To disable the Telnet service:
/>set inet telnet off
Committing configuration...done
See also set inet ftp
set interface beacon
Description Turns the beacon on an HP StorageWorks e2400-4Gb FC interface controller
on or off. Starts a wizard that prompts you for each interface controller that
has a beacon.
Syntax set interface beacon
Availability All users and modes
Operands None
Examples To turn on the beacon on interface controller 2:
206 CLI Command Reference