HP Interface Manager and Command View for Tape Libraries 3.7 User Guide

show net info

set net v6 manual

NOTE: To use this command, first enable IPv6 using the set net v6 ipversion command.

Description Configures the Interface Manager to accept a user-provided network address

for the public network interface.

Syntax set net v6 manual [[on] |

[off] force]

NOTE: The off argument removes all manually configured network addresses

Availability All users and modes

Operands [[on] | [off] force]

Examples To configure the Interface Manager to accept a user-provided network address

for the public network interface.:

/>set net v6 manual on

Add IPv6 address. Select Prefix

1) 2620:0:a07:e00a::

2) fe80::

Enter a selection or 'Q' to quit [default='Q']: 1

Enter interface identifier. xxxx:xxxx:xxxx:xxxx, a single

'::' is allowed.

Enter a selection or 'Q' to quit [default='Q']: a:b:c:d

Caution: Changing Manual addressing may cause your CLI

session to terminate(for a telnet/ssh user), and you may have

to log on again.

Do you really want to enable Manual addressing?

Enter 'y' to continue or 'n' to skip [default='n']: y

ipAddress = 2620:0000:0a07:e00a:000a:000b:000c:000d/64

Operation status: Starting to change network.

Operation status: Finished Updating Network Settings