HP Interface Manager and Command View for Tape Libraries 3.7 User Guide

---------------- ------------
myintfc1 2, 4
myintfc2 2, 4
***************************************************************
Interface write buffering: (Only displayed for service user or manual mode)
Interface Name Write Buffering
---------------- ---------------------
myintfc1 enabled
myintfc2 enabled
See also show drive info
show interface name
Description Shows the name and node WWN of one or more interfaces.
Syntax show interface name interface_num
Availability All users and modes
Operands Specify the interface number for which to display
interface names and world wide names. The information
interface_num
can be displayed for all interfaces by specifying all for
this operand. This operand is required.
Examples To show interface names and world wide names all interfaces:
/>show interface name all
Interface name information:
Interface Card Node WWN Current Name
-------------- ---------------- ------------
1 11111111111111CC myhost1
2 22222222222222CC myhost2
See also None
show interface revision
Description Shows the firmware revision of one or more interfaces.
Syntax show interface revision [interface_num] | [all]
Availability All users and modes
Operands Specify an interface whose firmware revisions will be
displayed. The firmware revisions may be displayed for
interface_num
all interfaces by specifying all for this operand. This
operand is required.
Examples To show the firmware revisions for all interfaces:
/>show interface revision all
Interface firmware revision:
Interface Card WW Node Name Firmware Revision
----------------- -------------------- -----------------
1 100000e0020286d1 5.01
2 100000e00202733b 5.01
See also show firmware revisions
show interface status
Description Shows the status of one or more interfaces.
Syntax show interface status [interface_num ] | [all]
Availability All users and modes
Operands Specify an interface for which to display the status. The
interface status may be displayed for all interfaces by
interface_num
specifying all for this operand. This operand is
required.
Examples To show the status for all interfaces:
show interface name 233