HP Interface Manager and Command View for Tape Libraries 3.7 User Guide

See also set mgmt timezone
set mgmt clock
show mgmt clock
show mgmt wwnstate
Description Shows the current World Wide Name (WWN) retention state for the Interface
Manager card. All WWN information shown is for the node name/ID. This
command is deprecated.
NOTE: In Command View TL versions 2.0 and later and Interface Manager
versions I200 and later the WWN retention state feature is always enabled.
The output of this command might not be shown correctly in the user interface.
Syntax show mgmt wwnstate
Availability All users and modes
Operands None
Examples To show the WWN retention state of the Interface Manager card:
/>show mgmt wwnstate
enabled
See also set mgmt wwnstate
set interface clearwwnmismatch
show interface wwninfo
show mode
Description Shows the current command mode.
Syntax show mode
Availability All users and modes
Operands None
Examples To show the current command mode:
/>show mode
Current command mode: manual
See also set mode
show network info
Description Displays the IPv4 and IPv6 network configuration of the public network
interface.
Syntax show network info
Availability All users and modes
Example To display the network configuration of the public network interface:
/>show net info
- Hostname: abslib27
- IP version(s) enabled: dualstack (both IPv4 and IPv6 enabled)
- IPv4 Domain Name: gr.hp.com
- IPv6 Domain Name: gr.ipv6.hp.com
- DHCPv4 enabled
- IPv4 addr/mask/gtwy: 192.168.100.16 / 255.255.0.0 /
- DHCPv6 enabled
- IPv6 stateless address autoconfiguration: enabled
- IPv6 manual addressing: enabled
show mgmt wwnstate 241