HP Interface Manager and Command View for Tape Libraries 3.7 User Guide

- IPv6 Addresses Type
2620:0000:0a07:e00a:0001:0002:0003:0004/manual
2620:0:a07:e00a:280:66ff:fe05:f956/64 stateless
2620:0:a07:e00a:485c:8517:cdb:6a83/64 dhcpv6
fe80::280:66ff:fe05:f956/64 link-lcl
See also set net v6 dhcpv6
set net v6 ipaddress
set net v6 ipversion
set net v6 manual
set net v6 stateless
show network dhcp
Description Shows whether DHCP mode is enabled or disabled. When enabled, DHCP
is used to set the Interface Manager card IP address.
Syntax show network dhcp
Availability All users and modes
Operands None
Examples To show whether DHCP mode is enabled or disabled:
/>show network dhcp
DHCP: disabled
See also set network dhcp
set network ipaddress
show network ipaddress
show network ipaddress
Description Displays the current IP address, subnet mask, and gateway address for the
Interface Manager card.
Syntax show network ipaddress
Availability All users and modes
Operands None
Examples To show the current IP address, subnet mask, and gateway address:
/>show network ipaddress
DHCP: disabled
IP address: 207.46.249.190
Subnet mask: 255.255.248.0
Gateway address: 207.46.72.1
See also show network dhcp
set network dhcp
set network ipaddress
show network snmpcommunity
Description Shows the Simple Network Management Protocol (SNMP) community strings.
SNMP is a well-defined standard of reporting device information through a
network. The Interface Manager card has a built-in SNMP agent that supports
queries to MIB-II in addition to SNMP traps/alerts. This command also shows
all defined SNMP traps.
Syntax show network snmpcommunity
Availability All users and modes
Operands None
242 CLI Command Reference