HP Interface Manager and Command View for Tape Libraries 3.7 User Guide

At the top of the dialog box, above the tabs, the following information appears:
Table 18 Viewing Drive Properties
DescriptionItem
The serial number of the drive.Drive Identification
The current status of the drive.Health
The serial number of the drive. This is a static value and
will change if a drive has been replaced. Use the serial
number when contacting HP support.
Serial Number
The serial number and barcode of the last tape loaded
into the drive.
Last Loaded Tape
The time at which the last sample was taken.Last Sample Time
This information remains visible when any tab is selected.
4. Click the Overview tab.
The Overview page appears.
Figure 7 Drive Properties window Overview tab
Information provided on the Overview page is explained in Table 19.
Table 19 Information available from the Drive Properties window Overview tab
DescriptionItem
Identification
The drive type including generation and interface type.Drive Type
The serial number of the drive. This value will change
if a drive has been replaced. Use the serial number
when contacting HP support.
Serial Number
The version of drive firmware the drive is currently
operating with.
Firmware Revision
An identifier that distinguishes the firmware among
multiple possible variants.
Firmware Personality
78 Command View TL GUI