HP P9000 Command View Advanced Edition Suite Software 7.4.1-00 CLI Reference Guide (TB581-96335, April 2013)

Parameters
Table 49 GetStorageArray (subtarget=ArrayGroup) command parameters
DescriptionStatusParameter name
Specify ArrayGroup.
Required
subtarget
Serial number of the storage system
If you omit this parameter, all the storage systems become the
target.
Optional
serialnum
Model of the storage system
If you omit this parameter, you will obtain information about the
models of all storage systems.
Optional
model
Object ID of the parity group in a storage system
Specify this parameter when you want to obtain the information
about a specific parity group. If you specify this parameter, you
must also specify the model and serialnum parameters.
If you specify the model and serialnum parameters without
specifying this parameter, the information about parity groups in
the specified storage system is acquired. Specify the object ID
obtained from another CLI response. The value is encoded by the
CLI.
Optional
objectid
Information obtained about a parity group or groups
The values you can specify are ExternalPathInfo,
LogicalUnit, PDEV, and
RelatedDistributedArrayGroup. If you specify multiple
values at the same time, separate the values by commas.
Optional
array-
groupsubinfo
Information about a logical unit
The values you can specify are Path and LDEV. If you specify
multiple values at the same time, separate the values by commas.
If you specify this parameter, you must also specify
arraygroupsubinfo=LogicalUnit.
Optional
lusubinfo
Starting sequence number of parity groups for which information
is to be obtained
Specify this parameter when you want to obtain information for
a part of parity groups in a specific storage system.
When parity group information is ordered as shown below and
numbered from 0 upward, specify the first number in the sequence
of parity groups that you want to obtain.
Order of parity groups:
1. Chassis numbers in ascending order
2. Parity group numbers in ascending order
This parameter must be specified together with the
numOfElementsFilter, model, and serialnum parameters.
Optional
startElement-
NumFilter
Command reference134