HP P9000 Command View Advanced Edition Suite Software 7.4.1-00 CLI Reference Guide (TB581-96335, April 2013)

DescriptionStatusParameter name
Virtual device number of the LDEV
Specify this parameter when you want to obtain information about
a specific virtual LDEV.
Specify this parameter as a decimal number or colon-delimited
hexadecimal number in the format ww:xx:yy, where ww is the
LDKC number, xx is the CU number, and yy is the LDEV number.
ww is optional. If ww is omitted, LDKC is assumed to be 0.
If you specify this parameter, you must also specify the vfamily,
vserialnum, and vrpusubinfo parameters. For the
vrpusubinfo parameter, specifyVLDEV.
The execution results are output in decimal.
Optional
vdevnum
Number of the first host storage domain for which information is
obtained
Specify this parameter when you want to obtain virtual information
about only some host storage domains in a specific storage system.
When host storage domains are ordered as shown below and
numbered from 0 upward, specify the number of the host storage
domain from which you want to start obtaining information.
Order of host storage domains:
1. Port IDs in ascending order
2. Domain IDs in ascending order
If you specify this parameter, you must also specify the model,
serialnum, vrpusubinfo, and numOfVhsdElementsFilter
parameters. For the vrpusubinfo parameter, specify
VHostStorageDomain.
Optional
startVhsdEle-
mentNumFilter
Number of host storage domains for which information is to be
obtained
Specify this parameter when you want to obtain virtual information
about only some of the host storage domains in a specific storage
system.
If you specify this parameter, you must also specify the model,
serialnum, vrpusubinfo, and
startVhsdElementNumFilter parameters. For the
vrpusubinfo parameter, specify VHostStorageDomain.
The maximum recommended value is 4096.
Optional
numOfVhsdEle-
mentsFilter
Number of the first LDEV for which information is obtained
Specify this parameter when you want to obtain virtual information
about only some of the LDEVs in a specific storage system.
When LDEVs are ordered by device number from 0 upward, specify
the number of the LDEV from which you want to start obtaining
information.
If you specify this parameter, you must also specify the model,
serialnum, vrpusubinfo, and
numOfVldevElementsFilter parameters. For the
vrpusubinfo parameter, specify VLDEV.
Optional
startVldevEle-
mentNumFilter
Command reference192